Menu
Menu
Close

Register an account with RME to store your favorite equipment and easily compare between units.

Register
  1. Home
  3. NEW AGRICULTURE EQUIPMENT
  5. New Holland Agriculture
  7. Combines & Headers
  9. Direct Cut Auger Heads
Direct Cut Auger Heads

Direct Cut Auger Heads

New Holland offers a complete selection of direct-cut heads, providing you with the versatility to match your crops and your operational needs. High-capacity rigid and flex heads deliver fast, clean cutting in tough field conditions, as well as reliable feeding, even in the heaviest crop conditions.

Direct Cut Auger Headers Brochure

Request Quote

Interested in this Direct Cut Auger Header unit but need some financing? Message us TODAY to speak with one of our financing specialists.

Financing Options

FLEXIBILITY FOR PRECISE HARVESTING EFFICIENCY

If you harvest in undulating terrain, the 740CF direct-cut SuperFlex™ auger head is the natural choice. Available in cutting widths of 25, 30, and 35 feet, 740CF heads feature a patented, rubber spring flotation system that allows heads to follow ground contours more closely so you get every bit of your crop. The SuperFlex knife bed flexes a full 4.5 inches to ensure a close cut and uniform stubble height in uneven fields.

EFFECTIVE FROM THE VERY START

The effectiveness of 740CF heads starts at the very front with crop dividers that present the most down and tangled crop to the six-bat reel, which smoothly conveys crop to the cutterbar and auger. When combined with 1150 cuts per minute and the cab-based, hydraulic, fore-and-aft reel adjustment, precise feeding and processing are a given. You can even maintain a pre-set ratio between reel speed and ground speed, so that when ground speed changes, feeding remains consistent.

CLOSE CUTTING

The cutterbar floor profile includes an integral hump that stops rocks from entering the cutterbar, while also preventing beans from rolling off the front. A shorter skid shoe design reduces weight and allows the cutterbar to cut closer to the ground for even better cutterbar flexing. The header height control system makes use of either four-sensor or two-sensor combine systems. The cutterbar uses standard three-inch guards and overserrated knife sections with 10 teeth per inch for clean cutting.

EASY FLOTATION ADJUSTMENT

You can manually adjust the rubber torsion springs on each floor support to adjust the flotation or to compensate for any unevenness in the cutterbar. Hydraulic cutterbar flotation adjustment is available as a dealer-installed accessory to allow you to make adjustments right from the combine cab.

SMOOTH FEEDING

A 26-inch-diameter auger with deep, five-inch flighting handles heavy crop and feeds it smoothly into the combine. A five-degree flatter auger floor angle enhances crop flow. Adjusting the auger up, down, fore and aft has been simplified. And, a new, patented rubber retention system prevents broken auger fingers from entering the combine.

 

Contact Us: 1-855-763-1427
About Us
Find Equipment
Promotional
Contact Us
Connect With Us
Sign up for deals & discounts

© Copyright 2025 – Rocky Mountain Equipment. All rights reserved.